Dell Force10 S25-01-GE-24T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1162

www.dell.com | support.dell.com show vlan private-vlan mapping Display primary-secondary VLAN mapping. switchport mode private-vlan Set the PVLAN mode of the selected port. show vlan private-vlan mapping c s Display primary-secondary VLAN mapping. Syntax show vlan private-vlan mapping Defaults none Command Modes EXEC EXEC Privilege Command History Usage Information Version 7.8.1.0 Introduced on C-Series and S-Series The output of this command, shown below, displays the community and isolated VLAN IDs that are associated with each primary VLAN. Figure 45-5. show vlan private-vlan mapping Command Output FTOS# show vlan private-vlan mapping Private Vlan: Primary : 100 Isolated : 102 Community : 101 Unknown : 200 Related Commands private-vlan mode show interfaces private-vlan show vlan private-vlan mapping switchport mode private-vlan Set the mode of the selected VLAN to either community or isolated. Display type and status of PVLAN interfaces. Display primary-secondary VLAN mapping. Set the PVLAN mode of the selected port. switchport mode private-vlan c s Set the PVLAN mode of the selected port. Syntax [no] switchport mode private-vlan {host | promiscuous | trunk} To remove the PVLAN mode from the selected port, use the no switchport mode private-vlan command. Parameters host Enter host to configure the selected port or port channel as an isolated interface in a PVLAN, as described above. 1162 | Private VLAN (PVLAN)