Dell Force10 S25-01-GE-24T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 552

www.dell.com | support.dell.com Version 7.5.1.0 Expanded to support the exclude and include options E-Series legacy command Usage Information A group in the include mode should have at least one source address defined. In exclude mode if no source address is specified, FTOS implicitly assumes all sources are included. If neither include or exclude is specified, FTOS implicitly assumes a IGMPv2 static join. Command Limitations • Only one mode (include or exclude) is permitted per multicast group per interface. To configure another mode, all sources belonging to the original mode must be unconfigured. • If a static configuration is present and a packet for the same group arrives on an interface, the dynamic entry will completely overwrite all the static configuration for the group. Related Commands show ip igmp groups Display IGMP group information ip igmp version c e s Manually set the version of the router to IGMPv2 or IGMPv3. Syntax ip igmp version {2 | 3} Parameters 2 3 Enter the number 2 to set the IGMP version number to IGMPv2. Enter the number 3 to set the IGMP version number to IGMPv3. Defaults Command Modes 2 (that is IGMPv2) INTERFACE Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.5.1.0 Introduced on S-Series Introduced on C-Series Introduced for E-Series show ip igmp groups c e s View the IGMP groups. Syntax show ip igmp groups [group-address [detail] | detail | interface [group-address [detail]]] 552 | Internet Group Management Protocol (IGMP)