Dell Force10 S25-01-GE-24T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 923

ipv6 mld snooping e Enable MLD Snooping (v1 and v2) on a VLAN. Syntax ipv6 mld snooping To disable MLD Snooping, use the no ipv6 mld snooping command. Defaults Enabled on all VLAN interfaces Command Modes INTERFACE VLAN (conf-if-vl-n) Command History Version 7.4.1.0 Introduced ipv6 mld snooping explicit-tracking e Enable explicit MLD Snooping tracking on an interface. Syntax ipv6 mld snooping explicit-tracking To disable, use the no ipv6 mld snooping explicit-tracking command. Defaults Disabled Command Modes INTERFACE VLAN (conf-if-vl-n) Command History Version 7.4.1.0 Introduced Usage Whether the switch is the Querier or not, if snooping is enabled, the switch tracks all MLD joins. It has Information separate explicit tracking table which contains group, source, interface, VLAN and reporter details. Related Commands show ipv6 mld snooping groups ipv6 mld snooping mrouter e Configure a Layer 2 port as a multicast router port. Syntax ipv6 mld snooping mrouter interface {interface} Parameters interface interface Enter the keyword interface to indicate the next-hop interface to the multicast router. Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Defaults No default values or behavior Multicast Listener Discovery (MLD) | 923