Dell Force10 S25-01-GE-24T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 407

Parameters ipv4-address | ipv6-address peer-group-name Enter the IP address of the neighbor for which you want to start storing inbound routing updates. Enter the name of the peer group for which you want to start storing inbound routing updates. Defaults Disabled Command Modes ROUTER BGP ADDRESS FAMILY (conf-router_bgp_af) Usage This command enables soft-reconfiguration for the specified BGP neighbor. BGP will store all updates Information for inbound IPv4 multicast routes received by the neighbor but will not reset the peer-session. Caution: Inbound update storage is a memory-intensive operation. The entire BGP update database from the neighbor is stored in memory regardless of the inbound policy results applied on the neighbor. Related Commands Command History show ip bgp neighbors Display routes received on a neighbor Version 8.4.1.0 Version 7.8.1.0 Version 7.7.1.0 Version 7.4.1.0 Added support for IPv4 multicast and IPv4 unicast address families Introduced support on S-Series Introduced support on C-Series Introduced network c et s Specify the networks for the BGP process and enter them in the BGP routing table. Syntax network ip-address mask [route-map map-name] To remove a network, use the no network ip-address mask [route-map map-name] command. Parameters ip-address mask route-map map-name Enter an IP address in dotted decimal format of the network. Enter the mask of the IP address in the slash prefix length format (for example, /24). The mask appears in command outputs in dotted decimal format (A.B.C.D). (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ip address • set community • set local-preference • set metric • set next-hop • set origin • set weight If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Border Gateway Protocol IPv4 (BGPv4) | 407