Dell Force10 S25-01-GE-24T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 670

www.dell.com | support.dell.com Figure 24-17. show ip interface brief Command Example (Partial) FTOS#show ip int brief Interface IP-Address GigabitEthernet 1/0 unassigned GigabitEthernet 1/1 unassigned GigabitEthernet 1/2 unassigned GigabitEthernet 1/3 unassigned GigabitEthernet 1/4 unassigned GigabitEthernet 1/5 10.10.10.1 GigabitEthernet 1/6 unassigned OK? Method Status Protocol NO Manual administratively down down NO Manual administratively down down YES Manual up up YES Manual up up YES Manual up up YES Manual up up NO Manual administratively down down Table 24-13. show ip interface brief Column Headings Field Interface IP-Address Ok? Method Status Protocol Description Displays type of interface and the associated slot and port number. Displays the IP address for the interface, if configured. Indicates if the hardware is functioning properly. Displays Manual if the configuration is read from the saved configuration. States whether the interface is enabled (up) or disabled (administratively down). States whether IP is enabled (up) or disabled (down) on the interface. show ip management-route c e View the IP addresses assigned to the Management interface. Syntax show ip management-route [all | connected | summary | static] Parameters all connected summary static (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all Management interfaces on the switch. (OPTIONAL) Enter the keyword connected to view only routes directly connected to the Management interface. (OPTIONAL) Enter the keyword summary to view a table listing the number of active and non-active routes and their sources. (OPTIONAL) Enter the keyword static to view non-active routes also. Command Modes Command History EXEC EXEC Privilege Version 8.1.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on E-Series ExaScale Introduced on C-Series Introduced for E-Series 670 | IPv4 Routing