Epson BrightLink 1480Fi Users Guide - Page 341
Solutions When an Afterimage Remains On the Projected Image, Solutions to Sound Problems
View all Epson BrightLink 1480Fi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 341 highlights
• Make sure all the cables are securely connected to the projector and your video device. If you connected long cables, try connecting shorter cables. • Position the projector close enough to the screen. • Make sure you have run the Light Source Calibration in the Management menu recently. If using multiple projectors, perform the calibration on all projectors to ensure a consistent image quality. Parent topic: Solving Image or Sound Problems Related references Input Signal Settings - Signal I/O Menu Administration Settings - Management Menu Image Quality Settings - Image Menu Solutions When an Afterimage Remains On the Projected Image If you see an afterimage in the projected image, select Refresh Mode > Start in the Management menu. Parent topic: Solving Image or Sound Problems Related references Administration Settings - Management Menu Solutions to Sound Problems If there is no sound when you expect it or the volume is too low or high, try the following solutions: • Adjust the projector's volume settings. • Press the A/V Mute button on the remote control to resume video and audio if they were temporarily stopped. • Check your computer or video source to make sure the volume is turned up and the audio output is set for the correct source. • Try disconnecting and reconnecting the audio cable. • Check the audio cable connections between the projector and your video source. • If you do not hear sound from an HDMI source, set the connected device to PCM output. • Make sure any connected audio cables are labeled "No Resistance." • If you are using the USB Display function, turn on the Output audio from the projector setting in the Epson USB Display Settings program on your computer. 341