Epson BrightLink 1480Fi Users Guide - Page 97

Setting Up Crestron Connected To set up your projector for monitoring and control using a Crestron Connected system, make sure your computer and projector are connected to the network. Note: If you want to use the Crestron Connected system when the projector is turned off, you need to adjust the Standby Mode setting in the Operation menu. The Standby Mode setting is displayed only if the A/V Output setting in the Signal I/O menu is set to While Projecting. 1. Press the Menu button. 2. Select the Network menu and press Enter. 3. Select Network Settings and press Enter. 4. Select the Projector Control menu and press Enter. 5. Set the Crestron Connected setting to On to allow the projector to be detected. Note: Enabling Crestron Connected disables the Epson Message Broadcasting feature in the Epson Projector Management software. 6. When you are finished selecting settings, select Return and press Enter to return to the Network Settings menu. 7. Select Set, and follow the on-screen instructions to save your settings and exit the menus. 8. Turn off the projector, then turn it on again to enable the setting. Parent topic: Using Crestron Connected Related references Input Signal Settings - Signal I/O Menu Network Settings - Network Menu Feature Settings - Operation Menu Controlling a Networked Projector Using Crestron Connected Once you have set up your projector to use Crestron Connected, you can control and monitor projection using a compatible web browser. 1. Start your web browser on a computer connected to the network. 2. Type the projector's IP address into the browser's address box and press the computer's Enter key. 97