Fujitsu MHN2150AT Manual/User Guide - Page 120

Interface then Automatic Acoustic Management is enabled. The AAM level setting is preserved by the drive across power on, hardware and software resets. AAM Level Standard Seek Slow Seek Reserved Sector Count register C0h-FEh, 00h 80h-BFh 01h-7Fh, FFh Standard Seek Slow Seek : Maximum performance : Minimum acoustic emanation (15) SET MULTIPLE MODE (X'C6') This command enables the device to perform the READ MULTIPLE and WRITE MULTIPLE commands. The block count (number of sectors in a block) for these commands are also specified by the SET MULTIPLE MODE command. The number of sectors per block is written into the Sector Count register. The IDD supports 2, 4, 8, 16 and 32 (sectors) as the block counts. Upon receipt of this command, the device sets the BSY bit of the Status register and checks the contents of the Sector Count register. If the contents of the Sector Count register is valid and is a supported block count, the value is stored for all subsequent READ MULTIPLE and WRITE MULTIPLE commands. Execution of these commands is then enabled. If the value of the Sector Count register is not a supported block count, an ABORTED COMMAND error is posted and the READ MULTIPLE and WRITE MULTIPLE commands are disabled. If the contents of the Sector Count register is 0, 1 when the SET MULTIPLE MODE command is issued, the READ MULTIPLE and WRITE MULTIPLE commands are disabled. When the SET MULTIPLE MODE command operation is completed, the device clears the BSY bit and generates an interrupt. 5-44 C141-E120-02EN