Garmin GTR 200 GTR 200 Installation Manual - Page 42
Unit Software, Checking Software Version, About Software Update
View all Garmin GTR 200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
3.7 Unit Software 3.7.1 Checking Software Version The GTR 200 comes pre-loaded with system software. However, if the software is out of date, it is recommended that current software be loaded from a micro SD card into the GTR 200. The current software version can be displayed in normal operation mode by pressing the MENU Key, then highlighting SETUP and pressing the SMALL Knob. The serial number, system software version, and boot block software version are displayed. Figure 3-14 About Page 3.7.2 Software Update The Software Update page (Figure 3-15) allows the installer to load unit software using a micro SD software loader card. Section 3.7.3 lists instructions on creating the loader card NOTE Garmin recommends the use of a 4GB micro SD card for updating unit software. Figure 3-15 Software Update Page GTR 200 Installation Manual Page 3-20 190-01553-00 Rev. A