HP 1606 HP B-series Fabric OS 6.4.1b Release Notes (5697-0886, March 2011-incl - Page 52

Table 9 Fabric OS 6.4.0 closed defects (continued) Closed defect summary Solution In a FICON environment, CUP incorrectly handles problem when sent Unsol Fixed in Fabric OS 6.4.0 Alert Status 0x82, and receives a Selective reset in response. Continues to retry the Unsol Alert on the same LP that received the Sel Reset. After Fabric OS Upgrade from 6.2.0e to 6.3.0b, user started seeing nonstop FICU-1015 error messages on the switches and CUP appears not to be working. User did hafailover on one of the switches, and error messages stopped. After removal and insertion of the HP StorageWorks Encryption blade, the lscfg --show command shows ASIC not ready errors and FW-5002 is observed in the internal raslog. Fixed in Fabric OS 6.4.0 After using the ipaddrset -cp command to set a host name of CP blade Fixed in Fabric OS 6.4.0 on any director switch, the standby CP incorrectly displays the host name of the CP, rather than the chassis host name. For the change to take effect after firmware upgrade, the user must logout, then log back in to see the change. If you set fwsettocustom, the HP StorageWorks DC SAN Backbone Fixed in Fabric OS 6.4.0 Director does not output FW-1003/FW-1004 after an hafailover or reboot, and the user is not notified about temperature over threshold events. In a remote corner case, an IPC failure message appears on one of the nodes Fixed in Fabric OS 6.4.0 when using the cryptocfg --show -groupmember -all command. Workaround prior to upgrade: Issue cryptocfg --show -groupcfg and cryptocfg --show -localEE commands instead to determine the health of EG. Intermittent SSH login failure SEC-1193 then SEC-1203, then works OK. Fixed in Fabric OS 6.4.0 The systemverification and portloopbacktest diagnostic tests report marginal blade failures on an HP StorageWorks DC SAN Director, but after the tests are complete, Fabric Watch reports switch is healthy. Fixed in Fabric OS 6.4.0 FICON Tape Emulation aborts from channel due to incorrect CCW number Fixed in Fabric OS 6.4.0 in generated command retry status for write conv busy sequences during Workaround prior to upgrade: tape pipelining. Disable FICON Tape Emulation. [Stress to Fail] Backend ports of 10/24 blade fails to come up during system Fixed in Fabric OS 6.4.0 verification test. Workaround prior to upgrade: Reboot. . CP fails to boot on DC SAN director, DC04 SAN director, and 8/80 SAN Fixed in Fabric OS 6.4.0 switch on power up or during hafailover and CF access error: HDA: drive not ready message may be seen on the console. Port LED status is not correctly displayed on Web Tools. Fixed in Fabric OS 6.4.0 When an XML string is being converted internally in CALD when the system Fixed in Fabric OS 6.4.0 is running out of memory, it causes an invalid memory access and results in a CALD process crash. TCP connection dropped on encryption switch or encryption blade due to Fixed in Fabric OS 6.4.0 lack of clean-up of locally managed socket Qualys security scan causes Web Linker restart. Fixed in Fabric OS 6.4.0 Host hangs while scanning LUNs. You can scan cleartext LUNs (0 and 1), but cannot scan encrypted LUNs 2 - 7 on certain device types. Related to unsupported Solaris Host Cluster setup, where host sent zero byte length Write commands. Fixed in Fabric OS 6.4.0 52