HP 1606 HP B-series Fabric OS 6.4.1b Release Notes (5697-0886, March 2011-incl - Page 60
On 4/64 SAN Switch, when HCL firmware download from Fabric OS 6.3, Brocade_SwitchFCPortStats
View all HP 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Table 9 Fabric OS 6.4.0 closed defects (continued) Closed defect summary Solution Invalid CAL response for CAL class Brocade_SwitchFCPortStats while Fixed in Fabric OS 6.4.0 EnumerateSelectedInstances operation for virtual port if the virtual port has invalid CAL property, haserror property sets to 1. So SMIAgent does not return the instances for the entire logical context. Unable to delete ACL for a port channel in CLI. Fixed in Fabric OS 6.4.0 Workaround prior to upgrade: Assign the ACL to an empty port-channel Then remove the ACL from the port-channel. Then delete the ACL. Trunking tab does not display the ICL's trunk link, whereas CLI trunkshow Fixed in Fabric OS 6.4.0 shows even if license is not installed. On certain target devices, portshow displays None on PWWN field while Fixed in Fabric OS 6.4.0 nsshow and switch displays PWWN on the port. Workaround prior to upgrade: Use nsshow or switch to get PWWN of the device. Encryption SAN switch - Blade processor fault when Out of Resource condition Fixed in Fabric OS 6.4.0 occurs and disables the ASIC. Transient detected error on internal link causes blade to be faulted with reason=5 or 4 on 8Gb port blades. Fixed in Fabric OS 6.4.0 Workaround prior to upgrade: Use slotpoweroff and slotpoweron to clear the fault. Inconsistency in encryption HACluster status, following an HA failover on Fixed in Fabric OS 6.4.0 a DC04 SAN director. Workaround prior to upgrade: Use portenable (ISL) or switchenable to fix the fabric. During bladeenable all blades + hafailover in a stress to fail test. One of the Fixed in Fabric OS 6.4.0 LISLs in a logical switch may get disabled due to zone conflict. Workaround prior to upgrade: Issue lfcfg --lislenable to recover the disabled lisl. On 4/64 SAN Switch, when HCL firmware download from Fabric OS 6.3 Fixed in Fabric OS 6.4.0 to 6.2.0g, observe termination of raslogd process. Prohibit Dynamic bit is not set in Port Descriptors when a port is prohibited Fixed in Fabric OS 6.4.0 only from itself. In a large fabric with more than 56 switches, edge DC SAN Backbone Fixed in Fabric OS 6.4.0 Director panics while doing switchdisable; agshow; switchenable loop with AG device, due to termination of msd during fabric reconfiguration. When the haSyncStart command is executed, the HA State synchronization has started message is not displayed. Fixed in Fabric OS 6.4.0 Workaround prior to upgrade: These are just info/display messages. No workaround is necessary. Run hashow to check the status of ha following hasyncstart or hasyncstop. Detected termination of process 0.weblinker.fcg:5110 after enabling port fencing for all E_Ports and F_Ports on the SAN when using DCFM. Fixed in Fabric OS 6.4.0 VE-port/FWconfigure utilization is above 100%, leading to RAS log showing Fixed in Fabric OS 6.4.0 more than 100% utilization. 60