HP 1x1x16 IP Console Switch User Guide - Page 93
Configuring Minicom, Option 3, through 6, Serial Port Setup.
View all HP 1x1x16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Network Settings 93 9. Select Option 3 through 6 from the Terminal Applications menu to finish configuring the console switch for an IP Address, Netmask, Default Gateway, and DNS. When this configuration is complete, enter 0 to return to the IPViewer HyperTerminal menu. Configuring Minicom NOTE: The example below is uses Red Hat 3.0. For more information, refer to your Linux operating systems HELP, or documentation. IMPORTANT: Minicom is a utility that is loaded during the installation of Linux. However, if you do not select the option to install the Linux Utilities during the operating system installation, you cannot use Minicom without downloading the Minicom X.X.i386.rpm file from the Red Hat website. (Refer to the procedure for installing RPMs on the Red Hat website.) To configure Minicom: 1. Log on to a Linux console, or open a terminal and enter minicom-s at the command prompt. The Configuration menu appears. 2. Select Serial Port Setup. The Change which setting? menu appears.