HP 3380 Service Manual - Page 148
Transfer upper guide assembly, Transfer roller, CAUTION
View all HP 3380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Note Transfer upper guide assembly It is not necessary to remove the front cover assembly. For clarity only, the front cover assembly is not shown in the following procedure. 1. Remove the printer top cover (see Printer top cover). 2. Remove two screws (callout 1). 1 Figure 5-57. CAUTION CAUTION Note Remove the transfer upper guide assembly Do not touch the black-sponge portion of the transfer roller. Lay a piece of paper over the roller before working in this area. 3. Lift the transfer upper guide assembly up and out of the printer. Reinstallation tip When installing the transfer upper guide assembly, install the right-side of the guide first to prevent it from lifting up during installation and to ensure that the tip of the ESD grounding spring is properly seated. Transfer roller Do not touch the black-sponge portion of the transfer roller. Lay a piece of paper over the roller before working in this area. A small grounding spring is located underneath the right side of the transfer roller. Do not misplace this grounding spring. 1. Open the print-cartridge door, and remove the print cartridge (see Print cartridge). 2. Use needle-nose pliers to gently squeeze the two small tabs on the transfer roller. 132 Chapter 5 Removal and replacement ENWW