HP 3380 Service Manual - Page 59

Loading originals to copy or scan Use these instructions to load originals into the product for copying or scanning. For the bestquality scans and copies, use the flatbed scanner. See Selecting originals for the automatic document feeder (ADF) for guidelines to choose original documents for scanning and copying. To load originals onto the flatbed scanner 1. Make sure that the ADF is clear and does not hold media. 2. Lift the flatbed scanner cover. 3. Place the original document face-down on the flatbed scanner, with the top, left corner of the document located in the lower-right corner of the glass. 4. Gently close the lid. 5. The document is ready to be copied or scanned. CAUTION To prevent damage to the product, do not allow the scanner lid to fall onto the flatbed scanner surface. Always close the scanner lid when the product is not in use. To load originals into the ADF input tray The ADF capacity is up to 50 sheets of 75-g/m2 (20-lb) media (depending on the thickness of the media), or until the ADF input tray is full. The minimum size for media in the ADF is 127 by 127 mm (5 by 5 inches). For smaller sizes, use the flatbed scanner. The maximum size for media in the ADF is 215.9 mm wide by 381 mm long (8.5 by 15 inches). 1. Make sure the flatbed scanner is clear and does not hold media. 2. Close the flatbed scanner cover and put the top end of the original media stack into the ADF input tray, with the media stack face-up and the first page to be scanned, copied, or faxed on top of the stack. 3. Slide the media stack into the ADF until the media does not move any farther. ENWW Loading originals to copy or scan 43