HP CB480A HP Color LaserJet CM4730 MFP - User Guide - Page 56

Table 2-12 Fax Setup menu (continued) Menu item Sub-menu item Sub-menu item Fax Send Settings Fax Dial Volume Error Correction Mode JBIG Compression Maximum Baud Rate TCF T.30 Delay Timer TCF Extend Dialing Mode Redial On Busy Redial On No Answer Values Description Off Low (default) High Enabled (default) Disabled Use this feature to set the volume of the tones that you hear while the device dials the fax number. When Error Correction Mode is enabled and an error occurs during fax transmission, the device sends or receives the error portion again. Enabled (default) Disabled JBIG compression reduces fax-transmission time, which can result in lower phone charges. However, using JBIG compression sometimes causes compatibility problems with older fax machines. If this occurs, turn off JBIG compression. Select a value from the list. The default is 33.6K. Use this feature to set the maximum baud rate for receiving faxes. This can be used as a diagnostic tool for troubleshooting fax problems. Default (default) Custom This setting should be left at the default value and only changed when directed by an HP technical support agent. Adjustment procedures associated with this setting are beyond the scope of this guide. Default (default) Custom This setting should be left at the default value and only changed when directed by an HP technical support agent. Adjustment procedures associated with this setting are beyond the scope of this guide. Tone (default) Pulse Select whether the device should use tone or pulse dialing. The range is between Type the number of times the device should 0 and 9. The factory attempt to redial if the line is busy. default is 3 times. Never (default) Once Twice Use this feature to specify the number of times the device should attempt to dial if the recipient fax number does not answer. NOTE Twice is available in locations other than the United States and Canada. 40 Chapter 2 Control panel ENWW