HP Designjet 510 HP Designjet 510 Printer series - Quick Reference Guide - Page 19
troubleshooting - memory
View all HP Designjet 510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
troubleshooting Message Out of memory. Data was lost Out of paper Paper advance calibration is recommended. Press ENTER to calibrate Paper loaded with too much skew Press ENTER to retry Press CANCEL to abort Explanation and action The file is too large to be processed by the printer. Simplify the print and try re-sending the job. Try setting the Print Quality (in the Set-up menu) to Fast or Normal instead of Best. If the problem persists, you may have to add more memory to the formatter card that is installed in the back of the printer. The printer ran out of paper while printing the calibration pattern. Load a sheet or roll that is at least 65 cm (25 inches) long and 50 cm (20 inches) wide. You are recommended to perform the Advance calibration routine, to ensure the optimum print quality. Press the Enter key to create the calibration pattern. During the loading of paper, the printer has detected that the paper is skewed too much, that is, it has not been loaded straight enough. ('Skew' is the angle between the actual paper edge and the correct line.) Either: Press the Enter key to restart the loading procedure; Or: Press the Cancel key to cancel paper loading. Front-panel error messages 19