HP ENVY dv4-5b00 HP Envy dv4 Maintenance and Service Guide - Page 61
Remove the system board, that secure the system board
View all HP ENVY dv4-5b00 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Remove the system board: 1. Disconnect the following cables from the system board: (1) Display panel cable (2) Speaker cable (3) Optical drive connector cable (4) Power connector cable 2. Remove the three Phillips M2.0×5.0 screws (1) that secure the system board to the base enclosure. 3. Lift the right side of the system board (2) until it rests at an angle. Component replacement procedures 53
Remove the system board:
1.
Disconnect the following cables from the system board:
(1)
Display panel cable
(2)
Speaker cable
(3)
Optical drive connector cable
(4)
Power connector cable
2.
Remove the three Phillips M2.0×5.0 screws
(1)
that secure the system board to
the base enclosure.
3.
Lift the right side of the system board
(2)
until it rests at an angle.
Component replacement procedures
53