HP EliteBook 8770w RAID User Guide - Page 20

SATA Device Mode, Confirm, Save Changes and Exit, Setup changes - power supply

Get HP EliteBook 8770w PDF manuals and user guides View all HP EliteBook 8770w manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

4. In the Device Configurations window, select RAID under SATA Device Mode. Click Confirm. The following message is displayed: "Changing this setting may require reinstallation of your operating system. Are you sure you want to proceed?" NOTE: The hard drive image supplied with your computer contains drivers that allow you to switch between AHCI and RAID modes without reinstalling the operating system. If you use a different hard drive image, you may need to reinstall the operating system. NOTE: Below SATA Device Mode, there is a check box for Ctrl I Prompt. If this is selected, the Intel option ROM screen is visible during the computer bootup time. 5. Select File > Save Changes and Exit. Then, click Yes to save the changes. If you do not want to apply your changes, select Ignore Changes and Exit. CAUTION: Do NOT turn the computer power off while the ROM is saving the f10 Computer Setup changes, because the Complementary Metal Oxide Semiconductor (CMOS) could become corrupted. Turn the computer off only after exiting the f10 Setup screen. 6. After the operating system boots, you can begin the RAID migration procedure. 16 Chapter 5 RAID volume setup

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
4.
In the Device Configurations window, select
RAID
under
SATA Device Mode
. Click
Confirm
.
The following message is displayed: “Changing this setting may require reinstallation of your
operating system. Are you sure you want to proceed?”
NOTE:
The hard drive image supplied with your computer contains drivers that allow you to
switch between AHCI and RAID modes without reinstalling the operating system. If you use a
different hard drive image, you may need to reinstall the operating system.
NOTE:
Below SATA Device Mode, there is a check box for Ctrl I Prompt. If this is selected, the
Intel option ROM screen is visible during the computer bootup time.
5.
Select
File
>
Save Changes and Exit
. Then, click
Yes
to save the changes. If you do not want
to apply your changes, select
Ignore Changes and Exit
.
CAUTION:
Do NOT turn the computer power off while the ROM is saving the
f10
Computer
Setup changes, because the Complementary Metal Oxide Semiconductor (CMOS) could
become corrupted. Turn the computer off only after exiting the
f10
Setup screen.
6.
After the operating system boots, you can begin the RAID migration procedure.
16
Chapter 5
RAID volume setup