HP Engage Go 13.5 Maintenance and Service Guide - Page 41
Touch board
View all HP Engage Go 13.5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
3. Disconnect the battery cable from the system board (see Battery on page 32). Remove the solid-state drive: 1. Use the tab to pull the plastic cover off the top of the drive (1). 2. Remove the screw that secures the drive (2). 3. Pull the drive out of the socket (3). To install the solid-state drive, reverse the removal procedure. Touch board To remove the touch board, use this procedure and illustration. Before removing the touch board, follow these steps: 1. Prepare the computer for disassembly (see Preparation for disassembly on page 31). 2. Remove the display assembly (see Display assembly on page 31). 3. Disconnect the battery cable from the system board (see Battery on page 32). Remove the touch board: 34 Chapter 5 Removal and replacement procedures