HP Engage Go 13.5 Maintenance and Service Guide - Page 44
Volume board and buttons
View all HP Engage Go 13.5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
1. Rotate the top WLAN antenna up. 2. Remove the antenna cable from the clips on the bottom of the speaker (1). 3. Disconnect the speaker cable from the system board (2). 4. Remove the two Phillips screws from the speaker (3). 5. Remove the speaker from the computer (4). To install the speaker, reverse the removal procedure. Volume board and buttons To remove the volume board and buttons, use this procedure and illustration. Before removing the volume board and buttons, follow these steps: Volume board and buttons 37
1.
Rotate the top WLAN antenna up.
2.
Remove the antenna cable from the clips on the bottom of the speaker
(1)
.
3.
Disconnect the speaker cable from the system board
(2)
.
4.
Remove the two Phillips screws from the speaker
(3)
.
5.
Remove the speaker from the computer
(4)
.
To install the speaker, reverse the removal procedure.
Volume board and buttons
To remove the volume board and buttons, use this procedure and illustration.
Before removing the volume board and buttons, follow these steps:
Volume board and buttons
37