HP Engage Go 13.5 Maintenance and Service Guide - Page 54
Camera LED cable, Volume board cable
View all HP Engage Go 13.5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
1. Disconnect the following cables from the system board: (1) Daughter board cable (2) Fingerprint reader cable (3) WLAN antennas cables (4) Ambient light sensor cable (5) Rear camera cable (6) Front camera cable (7) Camera LED cable (8) Power button board cable (9) Volume board cable (10) Pogo connector cable 2. Remove the card reader insert (1). 3. Remove the seven Phillips screws from the board (2). 4. Remove the USB bracket from the board (3). System board 47
1.
Disconnect the following cables from the system board:
(1)
Daughter board cable
(2)
Fingerprint reader cable
(3)
WLAN antennas cables
(4)
Ambient light sensor cable
(5)
Rear camera cable
(6)
Front camera cable
(7)
Camera LED cable
(8)
Power button board cable
(9)
Volume board cable
(10)
Pogo connector cable
2.
Remove the card reader insert
(1)
.
3.
Remove the seven Phillips screws from the board
(2)
.
4.
Remove the USB bracket from the board
(3)
.
System board
47