HP ProSignia 320 Desktop PC 6433C Compaq Deskpro Family of Personal Computers, - Page 65

POST Error Messages - Numbered, L = Long, S = Short

Get HP ProSignia 320 Desktop PC 6433C PDF manuals and user guides View all HP ProSignia 320 Desktop PC 6433C manuals
Add to My Manuals
Save this manual to your list of manuals

Page 65 highlights

POST Error Messages Continued Screen Message Beeps* 410-Audio Interrupt Conflict 2S Probable Cause IRQ address conflicts with another device. Recommended Action Reset the IRQ. 411-Network Interface Card 2S Interrupt Conflict IRQ address conflicts with another device. Reset the IRQ. 501-Display Adapter Failure 601-Diskette Controller Error 1L, 2S None Graphics display controller. 1. Reseat the graphics card (if applicable). 2. Clear CMOS. 3. Verify the monitor is attached and turned on. 4. Replace the graphics controller. Diskette controller circuitry or floppy drive circuitry incorrect. 1. Run Computer Setup (F10 Setup). 2. Check and/or replace cables. 3. Clear CMOS. 4. Replace diskette drive. 5. Replace the system board. 602-Diskette Boot Record Error None Diskette in drive A not bootable. Replace the diskette. 605-Diskette Drive Type 2S Error Mismatch in drive type. 1. Run Computer Setup (F10 Setup) or Windows NT, Windows 95, 98, or 2000 utilities. 2. Disconnect any other diskette controller devices (tape drives). 3. Clear CMOS. 610-External Storage Device Failure None External tape drive not connected. Reinstall tape drive or press F1 and allow system to reconfigure without the drive. 611-Primary Floppy Port 2S Address Assignment Conflict Configuration error. 1. Run Computer Setup (F10 Setup). 2. Remove expansion cards. 3. Clear CMOS. 612-Secondary Floppy Port 2S Address Assignment Conflict * L = Long, S = Short continued Configuration error. 1. Run Computer Setup (F10 Setup). 2. Remove expansion cards 3. Clear CMOS. B-4 POST Error Messages - Numbered

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
B-4
POST Error Messages - Numbered
POST Error Messages
Continued
Screen Message
Beeps*
Probable Cause
Recommended Action
410-Audio Interrupt Conflict
2S
IRQ address conflicts with
another device.
Reset the IRQ.
411-Network Interface Card
Interrupt Conflict
2S
IRQ address conflicts with
another device.
Reset the IRQ.
501-Display Adapter
Failure
1L, 2S
Graphics display controller.
1.
Reseat the graphics card (if
applicable).
2.
Clear CMOS.
3.
Verify the monitor is attached
and turned on.
4.
Replace the graphics
controller.
601-Diskette Controller
Error
None
Diskette controller circuitry
or floppy drive circuitry
incorrect.
1.
Run Computer Setup (F10
Setup).
2.
Check and/or replace cables.
3.
Clear CMOS.
4.
Replace diskette drive.
5.
Replace the system board.
602-Diskette Boot Record
Error
None
Diskette in drive A not
bootable.
Replace the diskette.
605-Diskette Drive Type
Error
2S
Mismatch in drive type.
1.
Run Computer Setup (F10
Setup) or Windows NT,
Windows 95, 98, or 2000
utilities.
2.
Disconnect any other diskette
controller devices (tape drives).
3.
Clear CMOS.
610-External Storage
Device Failure
None
External tape drive not
connected.
Reinstall tape drive or press F1 and
allow system to reconfigure without
the drive.
611-Primary Floppy Port
Address Assignment
Conflict
2S
Configuration error.
1.
Run Computer Setup (F10
Setup).
2.
Remove expansion cards.
3.
Clear CMOS.
612-Secondary Floppy Port
Address Assignment
Conflict
2S
Configuration error.
1.
Run Computer Setup (F10
Setup).
2.
Remove expansion cards
3.
Clear CMOS.
* L = Long, S = Short
continued