JVC TK-AM200U TK-AM200 Dome CCTV Camera Instruction Manual (748KB) - Page 9

Ceiling Mount % ^ ) 21 % ^ & % ^ ( 12 % * Ceiling Mount 15 Mounting holes (×4) Use these holes to attach the ceiling mount to the ceiling. System setting switches Set switches in accordance with the system to be connected to. The settings comprise setting the form of the control signal cable connection, communication protocol, control signal termination ON/OFF, and image synchronization method. ( See "Camera Settings" on page 14.) 16 Guide holes for mounting camera (×3) Guide holes for mounting the camera body. The camera body mounting guides 7 are inserted into these holes. 17 Camera direction alignment mark When mounting the ceiling mount to the ceiling, align this mark with the center of the direction in which you want the camera to face. 13 Camera ID setting switches Use to set the camera ID. Be sure to set the camera ID when switch 1 of the system setting switches 12 is set to ON (MULTIDROP). ( See "Camera Settings" on page 14.) 18 Camera clamping screw To hold the camera body in place, be sure to use this screw to clamp the camera clamp 8 . 19 Positioning alignment protrusion When attaching the camera body, align the camera clamp 8 on the camera body with this protrusion. 14 FOR SERVICE connector Exclusively for service purposes. 20 Drop prevention wire hook Attach this wire to the drop prevention wire hook 9 on the camera body. 21 Safety wire attachment hole To prevent the camera from accidentally dropping down, fasten a wire from the ceiling to this hole using an M3 screw. ( See "Ceiling Installation" step 2. on page 16.) 9