Kenmore 7808 Use and Care Guide - Page 13

4. Install the 2 hinges to the front panel of the dryer using 4 screws. Use the non-slotted side to attach the hinge to the front panel. 5. Install screws in the top hinge holes in the door. Do not tighten screws. Leave approximately 1/4"(5 ram) of screw exposed. 7. Check that the dryer is level. See "Level Dryer." 7f Electrical Shock Hazard A_ Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, A_ fire, or electrical shock. A. Instafl these screws firsL 6. Hang door by placing screw heads into top slotted holes of hinges and slide door down. Align bottom screw holes in hinge and door. Install two bottom screws. Tighten all hinge screws. 7. Close door to engage door strike. 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your tools. 3. Dispose of/recycle all packaging materials. 4. Be sure the water faucets are on. 5. Check for leaks around "Y" connector, faucet and hoses. 6. Check the dryer's final location. Be sure the vent is not crushed or kinked. 8. Plug into a grounded 3 prong outlet. Turn on power. 9. Remove any protective film or tape remaining on the dryer. NOTE: Glass door models have a protective film on the window that should be removed. 10. Read "Dryer Use." 11. Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust. 12. If you live in a hard water area, use of a water softener is recommended to control the buildup of scale through the water system in the dryer. Over time, the buildup of lime scale may clog different parts of the water system, which will reduce product performance. Excessive scale buildup may lead to the need for certain part replacement or repair. 13. Test dryer operation by selecting a Timed Dry heated cycle and starting the dryer. For this test, do not select the Air Only modifier. If the dryer will not start, check the following: Dryer is plugged into a grounded 3 prong outlet. Electrical supply is connected. Household fuse is intact and tight, or circuit breaker has not tripped. • Dryer door is closed. 14. When the dryer has been running for 5 minutes, open the dryer door and feel for heat. If you feel heat, cancel cycle and close door. If you do not feel heat, turn off the dryer and check that the gas supply line shutoff valve is open. • If the gas supply line shutoff valve is closed, open it, then repeat the 5-minute test as outlined above. • If the gas supply line shutoff valve is open, contact a qualified technician. 13