Kenmore 7808 Use and Care Guide - Page 21
Inside the, Dryer Cabinet, Exhaust, Non-Use, or Vacation, To winterize, dryer, To use dryer, again,
View all Kenmore 7808 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
4. Tumble a load of clean cloths or towels to dry drum. NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to avoid transfer of dye. From Inside the Dryer Cabinet Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified person. From the Exhaust Vent Lint should be removed every 2 years, or more often, depending on dryer usage. Replace inlet hoses and hose screen after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found. When replacing your inlet hoses, record the date of replacement. Install and store your dryer where it will not freeze. Because some water may stay in the hoses, freezing can damage your dryer. If storing or moving your dryer during freezing weather, winterize it. Non-Use or Vacation Care Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should: 1. Unplug dryer or disconnect power. 2. Closeshutoffvalve in gas supply line. 3. Clean lint screen. See "Cleaning the Lint Screen." 4. Turn off the water supply to the dryer. This helps to avoid unintended flooding (dueto a water pressure surge) while you are away. To winterize dryer 1. Unplug dryer or disconnect power. 2. Shut off water faucet. 3. Disconnect water inlet hose from faucet and drain. 4. Closeshutoffvalve in gas supply line. To use dryer again 1. Flush water pipes. Reconnect water inlet hose to faucet. Turn on water faucet. 2. Plug in dryer or reconnect power. 3. Open shutoff valve in gas supply line. Moving care 1. Unplug the power supply cord. 2. Close shutoffvalve in gas supply line. 3. Disconnect gas supply line pipe and remove fittings attached to dryer pipe. 4. Cap the open fuel supply line 5. Shut off water faucet. 6. Disconnect the water inlet hose from faucet, then drain the hose. Transport hose separately. 7. Make sure leveling legs are secure in dryer base. 8. Use masking tape to secure dryer door. Reinstalling the dryer Follow the "Installation Instructions" to locate, level and connect the dryer. The dryer light automatically turns on inside the dryer drum when you open the door. To change the drum light 1. Unplug dryer or disconnect power. 2. Open the dryer door. Locate the light bulb cover on the back wall of the dryer. Remove the screw located in the lower right corner of the cover Remove the cover. 3. Turn bulb counterclockwise. Replace the bulb with a lO-watt appliance bulb only. Replace the cover and secure with the screw. 4. Plug in dryer or reconnect power. 21