Kenwood KDC X493 Instruction Manual - Page 42
Connecting Wires to Terminals - wire harness
UPC - 019048182111
View all Kenwood KDC X493 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Connecting Wires to Terminals AUX input (Stereo) Use the mini-plug cable which is stereo type and does not have any resistance. USB connector Steering remote control (Light Blue/Yellow) REMO.CONT To use the steering wheel remote control feature, you need to an exclusive remote adapter (not supplied) matches your car is required. Front side Rear output R L Front output Sub Woofer output FM/AM antenna input Fuse (10A) Wiring harness (Accessory1) White White/Black Gray Gray/Black Green Green/Black Purple Purple/Black To Kenwood disc changer/ External optional accessory ⁄ To connect these leads, refer to the relevant instruction manuals. To front left speaker To front right speaker To rear left speaker To rear right speaker If no connections are made, do not let the wire come out from the tab. Power control wire (Blue/White) P.CONT Motor antenna control wire (Blue) ANT. CONT TEL mute wire (Brown) MUTE Dimmer control wire (Orange / White) ILLUMI When using the optional power amplifier, connect to its power control terminal. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type or short pole type antenna. Connect to the terminal that is grounded when either the telephone rings or during conversation. (KDC-X493/MP442U only) ⁄ To connect the Kenwood navigation system, consult your navigation manual. To car light control switch Ignition wire (Red) Car fuse box ACC Battery wire (Yellow) Ground wire (Black) · (To car chassis) 42 | KDC-BT742U/ KDC-X493/ KDC-MP442U + Ignition key switch Car fuse box (Main fuse) - Battery