Konica Minolta bizhub 4020i bizhub 5020i/4020i User Guide - Page 409
Perfect Forward Secrecy PFS, Local/ID Type/ID
View all Konica Minolta bizhub 4020i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 409 highlights
Type the time (seconds) and number of kilobytes (KByte) before the IPsec SA will expire. • Encapsulation Mode Select Transport or Tunnel. • Remote Router IP-Address Type the IP address (IPv4 or IPv6) of the remote router. Enter this information only when the Tunnel mode is selected. SA (Security Association) is an encrypted communication method using IPsec or IPv6 that exchanges and shares information, such as the encryption method and encryption key, in order to establish a secure communication channel before communication begins. SA may also refer to a virtual encrypted communication channel that has been established. The SA used for IPsec establishes the encryption method, exchanges the keys, and carries out mutual authentication according to the IKE (Internet Key Exchange) standard procedure. In addition, the SA is updated periodically. Perfect Forward Secrecy (PFS) PFS does not derive keys from previous keys that were used to encrypt messages. In addition, if a key that is used to encrypt a message was derived from a parent key, that parent key is not used to derive other keys. Therefore, even if a key is compromised, the damage will be limited only to the messages that were encrypted using that key. Select Enabled or Disabled. Authentication Method Select the authentication method. Select Pre-Shared Key or Certificates. Pre-Shared Key When encrypting communication, the encryption key is exchanged and shared beforehand using another channel. If you selected Pre-Shared Key for the Authentication Method, type the Pre-Shared Key (up to 32 characters). • Local/ID Type/ID Select the sender's ID type, and then type the ID. Select IPv4 Address, IPv6 Address, FQDN, E-mail Address, or Certificate for the type. If you select Certificate, type the common name of the certificate in the ID field. • Remote/ID Type/ID Select the recipient's ID type, and then type the ID. Select IPv4 Address, IPv6 Address, FQDN, E-mail Address, or Certificate for the type. If you select Certificate, type the common name of the certificate in the ID field. Certificate If you selected Certificates for Authentication Method, select the certificate. You can select only the certificates that were created using the Certificate page of Web Based Management's Security configuration screen. Related Information • Configure an IPsec Template Using Web Based Management 403