Kyocera FS-C8500DN FS-C8500DN Printer Driver User Guide Ver. 11.6 - Page 48
Stapling a Print Job, Punch, Setting Punch Options
View all Kyocera FS-C8500DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Finishing Punch 6-4 Staple selects the Destination automatically. If the Finishing options are changed, the Destination selection is not affected. Stapling a Print Job The Staple feature in the Finishing tab enables you to create stapled document sets. You must first select a finisher under Device options in the Device Settings tab. Staple will make Separation and Transparency interleaving unavailable. The maximum number of sheets depends upon the finisher model and the selected Page size or Media type. The Gutter feature lets you increase the top and left margins to accommodate the location of the staples. 1 In the Finishing tab, select Staple. 2 In the Staple feature, select Position and Count. Two options are available for count: All sheets up to the limit displayed in the tab, and every number of pages so that each number set is stapled separately. The Position setting options vary based on settings in Finishing edge, which provides custom staple locations in the document. 3 Click OK to return to the Print dialog box. 4 Click OK to start printing. The Punch feature places punches along the edge of the printed pages so that the pages can be bound together or placed in a binder. Punch is enabled when a 3000-sheet finisher is selected in Device options in the Device Settings tab. When you select the check box for a finishing device shown in blue in the Device options list, the Punch Unit Settings dialog box appears. If the device listing is already selected, double-click the option to open the Punch Unit Settings dialog box. Punch cannot be used when Booklet is selected in the Layout tab. Setting Punch Options Before using the Punch option in the Finishing tab, you must set punch options in the Device Settings tab. The selected option is available under Punch in the Finishing tab. 1 In the Device Settings tab, under Device options, select 3000-sheet finisher. Or if already selected, double-click the blue text. 2 Depending on the punch unit attached, select one option: None No punch option available in the Finishing tab. 2 hole 2 hole option available in the Finishing tab. 2 & 3 hole 2 hole and 3 hole options available in the Finishing tab (inches based). User Guide