Lexmark 12N0009 Finisher Setup and User's Guide - Page 15
Aligning the finisher and printer, Setup, click
UPC - 734646560092
View all Lexmark 12N0009 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Alignment marks Aligning the finisher and printer Docking plate pin The following three areas must align properly to prevent paper jams. 1 The docking plate pins must enter the holes in the finisher. 2 The space between the printer and finisher must be the same at the top and bottom of the finisher. 3 The alignment marks on top of the finisher must align with the edges of the cover on the side of the printer. Spacing Hole in finisher 4 Roll the finisher toward the printer until the finisher locks to the docking plate pins. You hear a click when the finisher locks into position. If the pins did not go into the holes in the finisher, see "Lowering or raising the finisher" on page 12. Otherwise, go to "Aligning the sides of the finisher" on page 13. Setup 11