Lexmark Optra C710 Service Manual - Page 181
Diagnostic Information, Paper Jam 24x displays, media tries to feed from tray x and does
View all Lexmark Optra C710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 181 highlights
5016-001 F Paper Jam 24x displays, media tries to feed from tray x and does not reach the paper pass sensor. FRU 1 Paper Tray x 2 Option Paper Pass Through Sensor Flag Tray x 3 Paper Feed: • Roller • Paper Pick Up Roller • Pick Up Gear • Pick Up Roller Idler Gears Action Check Tray x for anything that might cause the paper to jam in the tray, or prevent the media from exiting. Check the option paper pass sensor flag for signs of broken parts and that the flag is operating properly. Repair as necessary. Check the voltages on connector CN804 on the option interconnect board. Pin # 1 (Orange) 2 (Yellow) 3 (Green) SIgnal Voltage GND Pass VL Voltage Voltage Static Sensor Closed 0 V dc 0 V dc +3.6 V dc 0 - 3.6 V dc +5.0 V dc +5.0 V dc • If the static voltages are correct and the sensor does not change when activated, replace the sensor. • If the voltages are incorrect, replace the option interconnect board. Check the following paper feed parts for signs of broken teeth, excessive wear, or binding: • Paper feed unit clutch. • Paper feed roller shaft, paper transfer roller drive gear and paper feed roller. • Paper transfer roller and paper transfer roller idler gears. • Paper pick up roller, paper pick up gear, paper pick up roller idler gears. If problems are found, repair or replace as necessary. Diagnostic Information 2-115