Lexmark Optra C710 Service Manual - Page 68

5016-001 Service Error Codes Service Error Codes are generally non-recoverable except in an intermittent condition, when you can POR the printer to temporarily recover from the error condition. Error Code Action 900 RIP Software Contact your customer service center, or the Lexmark Customer Support Center. 910 DC Motor (1) Locking error - the motor did not stabilize. Go to the "OPC Drive Service Check" on page 2-66. 911 DC Motor (2) Locking error - the motor did not stabilize. Go to the "Developer/Paper Feed Motor Service Check" on page 2-48. 912 DC Motor The motor stabilized then locking was released. Go to the "Developer/Paper Feed Motor Service Check" on page 2-48. 917 Transfer Belt Go to the "ITM Drive Service Check" on page 2-60. 918 Fan Stalled The main fan has stalled, or locked up. Go to the "Main Fan Service Check" on page 2-62. Note: The following errors are detected when the printer is below the maintenance count. 920 Fuser Error 921 Fuser Error 922 Fuser Error 923 Fuser Error 924 Fuser Error Indicates that the fuser is below temperature when printing. Go to the "Fuser Cold Service Check" on page 2-51. Indicates that the fuser is below temperature and the system is detecting a thermistor short. Go to the "Fuser Cold Service Check" on page 2-51. Indicates that the fuser temperature failed to increase. Go to the "Fuser Cold Service Check" on page 2-51. Fuser is too hot during printing or when printer is idle. Go to the "Fuser Hot Service Check" on page 2-57. Indicates that the system has detected that the thermistor is open. Go to the "Fuser Hot Service Check" on page 2-57. 2-2 Service Manual