Lexmark Optra C710 Service Manual - Page 183
Diagnostic Information, Paper Jam 24x displays, media is detected and fed from tray x
View all Lexmark Optra C710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
5016-001 FRU 4 CST Cable Engine Board Action Check continuity of the cable. • If incorrect, replace the cable. • If correct, replace the engine board. H Paper Jam 24x displays, media is detected and fed from tray x and paper jams over the paper pass sensor in the base printer. FRU 1 Paper Pass Sensor: • Flag • Spring • Board MK2 Cable Engine Board Action Check the paper pass sensor flag and spring for correct operation and broken or loose parts. If a problem is found, repair as necessary. The voltages for the paper pass sensor can be checked at the 6 pin inline cable connector, located in the HVPS to engine board cable harness above the temperature/humidity board assembly, on the left side of the printer. Voltages on the inline connector. Pin # 3 (Orange) 4 (Blue) 5 (Brown) 6 (Green) Voltage Static +5 V dc +5 V dc +5 V dc 0 V dc Voltage Feeding +5 V dc 0 V dc to +5 0 V dc to +5 0 V dc Note: All voltages are approximate. • If the voltage on pin 3 is incorrect, check continuity of the cable. If incorrect and If the cable is good, replace the engine board. • If the voltage on pin 3 is correct but the voltage on pin 4 is incorrect, replace the following parts in the order shown: 1. Paper pass sensor board assembly 2. Engine board 3. MK 2 cable Diagnostic Information 2-117