Netgear WN604-100NAS Reference Manual - Page 73
Restore to factory default settings, Apply, password, Reboot., Reset to Factory Defaults.
View all Netgear WN604-100NAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
NETGEAR Wireless N150 Access Point WN604 Reference Manual Figure 4-4 Restore to factory defaults 2. On the Restore Defaults screen, enable the Restore to factory default settings option by selecting the Yes radio button. 3. Click Apply to reset to the factory default settings. After a restore, the wireless access point password will be password, the default LAN IP address will be 192.168.0.100, and the access point name will reset to the name printed on the label on the bottom of the unit. To restore the factory default configuration settings without knowing the login password or IP address, you must use the Default Reset button on the rear panel of the wireless access point (see Figure 1-1 on page 1-6). The reset button has two functions: • Reboot. When pressed and released, the Wireless Access Point will reboot (restart). • Reset to Factory Defaults. This button can also be used to clear all data and restore all settings to the factory default values. To clear all data and restore the factory default values: 1. Power off the WN604. 2. Use something with a small point, such as a pen, hold the Reset button for 5 seconds while you Power On the WN604. 3. Continue holding the Reset Button until the LEDs blink twice. Management 4-5 v1.0, March 2010