Oki ML591 Microline 590/591 User's Guide - Page 67
Full Operation, 1 CPI, Valid, Black Ribbon, Invalid, Ready/Busy, Ready on Power Up, Auto Gap
View all Oki ML591 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
R-1 57 Group Set-Up (continued) Item Operator Panel Function Settings Full Operation, Limited Operation Print Registration 0, 0.05 mm Left, 0.10 mm Left, 0.15 mm Left, 0.20 mm Left, 0.25 mm Left, 0.25 mm Right, 0.20 mm Right, 0.15 mm Right, 0.10 mm Right, 0.05 mm Right Reset Inhibit No, Yes Print Suppress Effective Yes, No Parallel I/F Serial I/F (appears only when optional Serial Interface is installed) CSF Bin 1 (appears only with optional Cut Sheet Feeder installed) Auto LF Auto CR (appears only when IBM Proprinter emulation is selected) SI Select Pitch, 10 cpi (appears only when IBM Proprinter emulation is selected) SI Select Pitch, 12 cpi (appears only when IBM Proprinter emulation is selected) Time Out Print Auto Select Ribbon Selection (Optional color ribbon must be installed in order to print in colors other than black) Printhead Gap Adjust Graphics Speed I-Prime Pin 18 Auto Feed XT (appears only when Epson LQ emulation is selected) Parity Serial Data 7/8 Bits Protocol Diagnostic Test Baud Rate Busy Line DSR Signal DTR Signal Busy Time Line Spacing Bottom Margin Page Width (Model 591 only) Page Length Gap Control No, Yes No, Yes 17.1 CPI, 15 CPI 20 CPI, 12 CPI Valid, Invalid No, Yes Black Ribbon, Black, Yellow, Magenta, Cyan, Violet, Orange, Green 0, -1, +1 High, Low Buffer Print, Buffer Clear, Invalid +5v, Open Invalid, Valid None, Odd, Even 8 Bits, 7 Bits Ready/Busy, X-On/X-Off No, Yes 19200 bps, 9600 bps, 4800 bps, 2400 bps, 1200 bps, 600 bps, 300 bps SSD-, SSD+, DTR, RTS Valid, Invalid Ready on Power Up, Ready on Select 200 ms, 1 sec 6 LPI, 8 LPI Valid, Invalid 13.6", 8.5" 11", 11-2/3", 12", 14", 17", 3", 3.5", 4", 5.5", 6", 7", 8", 8.5" Auto Gap, Semi Auto Gap, 1, 2, 3, 4, 5, 6, 7, 8, 9