Panasonic AG-HMC80PJ User Manual - Page 93

Chapter 3: Screen displays and setting menus 8 Remaining battery capacity display When using Panasonic-manufactured batteries compatible with this product, the remaining battery capacity is displayed ("min" indicates minutes). Time remaining will be displayed after a brief pause. • The battery display will change → → → → as battery capacity decreases. will be displayed in red when less than 3 minutes are remaining, and will flash when the battery is empty. • Remaining battery capacity may not be displayed correctly when using in high or low temperatures, or when the battery has not been used for a long period of time. To ensure that remaining battery capacity is displayed correctly, use the battery completely from a fully-charged state, and charge the battery again. (Remaining battery capacity may still not be displayed correctly if the battery has been used for long periods in high or low temperatures, or if the battery has been recharged a large number of times.) • The remaining battery capacity display is a guideline and may change according to usage conditions. • The remaining battery capacity display will momentarily disappear when switching between modes, when conducting REC CHECK operations or when changing the LCD brightness since the capacity is recalculated at these times. • Not displayed when using AC adaptor. 9 Media information display Displays basic information about inserted SD Memory Card. : (Flashing) (White) Playback possible (Green) Recognizing card : (Red) Card not inserted 10 Metadata mark Displayed when the META DATA REC item in the setting menu RECORD SETUP screen is set to ON. (Page 104) 11 Quality display Displays the image quality during PHOTO mode. 12 DV control device status display (DV mode only) Displays status of devices connected to the DV terminal. DV : Recording DV : (Green) Recording standby DV : Device cannot be controlled DV: Device is not connected DV ---: Device cannot record and go on recording standby 13 DV IN PRESET display (DV mode only) Displayed when set to 1394 TC preset mode. (Page 73) 14 Recording pixel display Displays the recording pixels during PHOTO mode. 15 DV mode display (DV MODE only) Displayed when DV mode is selected with the MODE switch. 16 Recording format display (Page 103) 17 Frame rate display Displays recording frame rate. Not displayed when set to 60i. 18 Shutter speed display The shutter speed is displayed here. 19 Recording aspect display (DV mode only) (Page 103) 20 Focus bar display*1 Displayed when the FOCUS ASSIST SW item in the setting menu SW&DISP SETUP screen is set to BAR. 21 Time stamp display (Page 103) 22 Face detection frame display Displayed when the FACE FRAMING item in the setting menu SW&DISP SETUP screen is set to PRIMARY or ALL, and FACE DETECT ON is enabled. 23 Optical Image Stabilizer display Displayed when Optical Image Stabilizer is ON. 24 Digital zoom ratio display Displays digital zoom ratio. D 2X: 2 x zoom D 5X: 5 x zoom D 10X: 10 x zoom *1 Will not be output to external devices. (Continued on the next page) 93