Panasonic DMR-ES40VS DMRES40 User Guide - Page 18

Getting started STEP 4 Set up to match your TV and remote control DVD/VHS POWER TV POWER INPUT SELECT TV/VIDEO CH VOLUME Numbered buttons 3, 4, 2, 1 ENTER VHS OPERATION SELECT DVD TRACKING/V-LOCK AUDIO CANCEL/RESET SKIP/INDEX VCR Plus+ CM SKIP PLAY SLOW/ REW SEARCH FF DIRECT NAVIGATOR PFLUANYCTIONS TOP MENU SUB MENU S RETURN REC REC MODE DVD ERASE TAIDMDE/DSLLTIP SCHEDULE DISPLAY STATUS JET REW DUBBING CREATE CHAPTER VCR/TV VHS DVD TV, Í CH, W, X FUNCTIONS RETURN VCR/TV ∫ To exit the screen Press [RETURN] several times. ∫ TV operation To turn the TV on/off, change the TV input mode, select the TV channel and change the TV volume by means of this remote control, set the remote control as follows. Point the remote control at the TV While pressing [Í POWER TV], enter the code using the numbered buttons. e.g., 01: press [0] > [1]. Manufacturer and Code No. Panasonic National QUASAR 01, 02 PHILIPS (RC-5) RCA SAMSUNG 03 05 14, 18, 19 FISHER 10 SANYO 10 GE 05 SHARP 06, 07 GOLDSTAR 15, 16, 17 SONY 08 HITACHI 12 SYLVANIA 03 JVC 11 THOMSON 05 LG 15, 16, 17 TOSHIBA 09 ∫ When other Panasonic products respond MAGNAVOX 03 ZENITH 04 to this remote control MITSUBISHI 13 If other Panasonic products are placed close together, change the remote control code on the main unit and on the remote control (the two must match). When changing the remote control code, make sure the two codes are same. Under normal circumstances use the factory set code "1". ≥Test by turning on the TV and changing channels. Repeat the procedure until you find the code that allows correct operation. ≥If your TV brand is not listed or if the code listed for your TV does not allow control of your TV, this remote control is not compatible with your TV. [1] While stopped Press [FUNCTIONS]. [2] Select "Other Functions" with [3, 4] FUNCTIONS DVD DVD-RAM Playback DIRECT NAVIGATOR Schedule SCHEDULE 123 VCR Plus+ Cartridge Protection Off Disc Protection Off PLAYLISTS FLEXIBLE RECORDING DV AUTO RECORDING SETUP DISC MANAGEMENT and press [ENTER]. [3] Select "SETUP" with [3, 4] and press ENTER Other Functions Return [ENTER]. [4] Select "Setup" with [3, 4] and press [2, 1]. [5] Select "Remote Control Code" with [3, 4] and press [ENTER]. [6] Use [3, 4] to select the code (1, 2 or 3) and press [ENTER]. ≥The code on the unit has been set. [7] While pressing [ENTER], press and hold the numbered button ([1], [2] or [3]) corresponding to the code you selected in step 6 for about 2 seconds. ≥The code on the remote control has been set. [8] Press [ENTER]. ∫ When the following indicator appears on the unit's display The unit's remote control code Change the code on the remote control to match the main unit's code (l step 7). ∫ To return to the previous screen 18 Press [RETURN]. VQT0R73