Panasonic WJRT416V WJRT416V User Guide - Page 63

Configure the settings relating to communications with other devices [Communication Setup] It is necessary to conform the setting such as the communication protocol and the line speed when connecting an external device such as a system controller to the DATA port or the RS485 port. It is also necessary to configure the network settings such as the IP address and the gateway address to operate the recorder using a PC via a network. The following is the required setting to communicate with external devices. Communication Setup Network Setup RS485 Setup PS.Data Setup q w e q Configure the network settings [Network Setup] To operate the recorder using a PC via a network, configure the basic network settings. Network Setup DHCP IP Address Subnet Mask Gateway Line Speed Advanced Setup Off 192.168.000.250 255.255.255.000 192.168.000.001 Auto Set→ OK Cancel DHCP Select "On" or "Off" to determine whether or not to use the DHCP server. Select "On" when obtaining values for "IP Address", "Subnet Mask" and "Gateway" from the DHCP server. Select "Off" when entering values for "IP Address", "Subnet Mask" and "Gateway" manually. On: Use the DHCP server Off: Not use the DHCP server Default: off IP Address Enter an IP address. For this recorder, enter 4 units from the decimal numbers (0-255). Default: 192.168.0.250 Subnet Mask Enter a subnet mask according to the network configuration. Default: 255.255.255.000 Gateway Enter a gateway address according to the network configuration. Default: 192.168.0.1 Line Speed The following is available for the line speed. Auto: Line speed will be applied automatically. 100M-Half: 100 Mbps half duplex 10M-Half: 10 Mbps half duplex 100M-Full: 100 Mbps full duplex 10M-Full: 10 Mbps full duplex Default: Auto 63