Panasonic WVCW384 WVCW384 User Guide - Page 27
White Balance Setting WHITE BAL, Motion Detection Setting MOTION DET, AWC Setting
UPC - 791871505830
View all Panasonic WVCW384 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
• Select a proper "FINE" phase so that the two video signals on the oscilloscope come as close as possible. Notes: • Moving the "I" cursor across the +/- end will shift the "FINE" range. • Press the [LEFT] and [RIGHT] buttons simultaneously to reset the "V PHASE" to the default (0 degree). • Keep pressing the [LEFT] and [RIGHT] buttons for a second to move the "I" cursor faster if necessary. • Spike noise if contained in the AC mains may disturb synchronization of LL. 7. White Balance Setting (WHITE BAL) Select a mode for "WHITE BAL" on the "CAMERA SETUP" menu. The default setting is "ATW1". ATW1: Is automatically adaptable to the color temperatures of 2 700 K - 6 000 K. ATW2: Is automatically adaptable to the use of sodium lamps (2 000 K - 6 000 K). AWC: Is automatically adaptable to the color temperatures of 2 000 K - 10 000 K. Notes: • When "ATW1" or "ATW2" is selected, no further operation is required. • "ATW1" and "ATW2" do not appear on the setup menu of the system controller. • Select "AWC" in the following cases: the color temperature is out of the 2 000 K - 6 000 K range, the scene contains mostly high color temperatures such as blue sky or sunset, or the scene is dim. • When "AWC" is selected, the "AWC" setting is required. AWC Setting 1. Select "AWC" and press the [LEFT] button. → "AWC" will change to "AWC → PUSH SW". 2. Press the [SET] button. → "PUSH SW" will be highlighted while the "AWC" setting is performed. Note: • If the white balance is not set, "PUSH SW" is being highlighted. 3. Press the [RIGHT] button. Manual Fine Adjustment Perform fine adjustment as necessary. 1. Select "WHITE BAL" and press the [SET] button. → Fine adjustment menu of ATW or AWC will open. 2. Adjust finely "R" (Red) and "B" (Blue) gain by moving the "I" cursor. **ATW1** R ...I...128 - + B ...I...128 - + RET TOP END 8. Motion Detection Setting (MOTION DET) When a series of changes in pictures is detected, the camera outputs an alarm to the external device such as a disk recorder. The recorder will start recording the pictures. 1. Select a mode for "MOTION DET" on the "CAMERA SETUP" menu. The default setting is "OFF". OFF: Disables the alarm output. MODE1: Outputs alarm when a series of motions is detected. MODE2: Outputs alarm when a series of scene changes is detected. → The "MODE1" menu opens when you select "MODE1" and press the [SET] button. 2. Adjust for "LEVEL" to optimize the sensitivity of detection. ** MODE1 ** LEVEL DWELL TIME ...I...128 - + 2S DISPLAY MODE ALARM OFF MASK SET RET TOP END 27