Panasonic WVCW384 WVCW384 User Guide - Page 9

Precautions for Installation Installing place Contact your dealer for assistance if you are unsure of an appropriate place in your particular environment. Make sure that the installation area is strong enough to hold this product, such as a concrete ceiling. When the installation area is not strong enough, reinforce and strengthen it. Avoid installing this product in the following locations. • Locations where a chemical agent is used such as a swimming pool • Locations subject to steam and oil smoke such as a kitchen • Locations near flammable gas or vapor • Locations where radiation or x-ray emissions are produced • Locations subject to strong magnetic field or radio waves • Locations where corrosive gas is produced • Locations where it may be damaged by briny air such as seashores • Locations where the temperature is not within -30 °C to +50 °C {22 °F to 122 °F}*. * -10 °C to +50 °C {14 °F to 122 °F} at 12 V DC • Locations subject to vibrations (This product is not designed for on-vehicle use.) Be sure to remove this product if it is not in use. White balance White balance may be not adjusted appropriately in the following cases. • When a subject is extremely less white or nearly single colored • When a subject is in the outdoors in the morning or evening or in the low illuminance state • When a subject is in the atmosphere of extremely different color temperature (e.g. under color illumination) Keep the video output cable away from the lighting cable. Failure to observe this may cause noise. Radio interference When this product is used near TV/radio antenna, strong electric field or magnetic field (near a motor or a transformer), images may be distorted and noise sound may be produced. In such a case, run the camera cable through specialized conduit tubes. Mounting screws Only the fixing screws are provided to fix this product with the provided mount bracket. It is necessary to procure screws or bolts to mount the product. Prepare them according to the material and strength of the area where the product is to be installed. The screws and bolts must be tightened with an appropriate tightening torque according to the material and strength of the installation area. After tightening the screws or bolts, perform visual check to ensure tightening is enough and there is no backlash. Piping for cables If this product is operated outdoors, be sure to install connecting tubes and run the cables through the tubes to protect the cables from being frozen or direct sunlight. 9