Panasonic microP2 Handheld AVC-ULTRA HD Camcorder Operating Instructions Basic - Page 106
Connecting and setting the genlock and time code input/output, Setting and displaying the counter
View all Panasonic microP2 Handheld AVC-ULTRA HD Camcorder manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Chapter 4 Shooting - Setting the time data 3 Set [TCG/TCR] in the main menu → [OUTPUT SEL] → [TC OUT]. @@NOTE tt If you set [TC OUTPUT REF] to [VIDEO OUT] in the main menu → [OUTPUT SEL], the input time code will be output to match the video output delay. Connecting and setting the genlock and time code input/output The relationship of the connecting and settings between the genlock and time code input/output is shown in the table. When the genlock input and the camera output phase match, l is displayed, and when they do not match, × is displayed. rr When the camera recording format is 1080P, 1080i Camera usage conditions Camera settings Genlock input and camera output phase Image and standard signals supplied externally Genlock input [GL PHASE] SDI output (HD) Video output and SDI output (SD) Time code output SDI VIDEO [HD SDI] l 1080i [COMPOSITE] 90H advance 90H delay l l l SDI VIDEO SD (480i/576i) [HD SDI] [COMPOSITE] l 90H advance 90H delay l l l rr When the camera recording format is 1080/23.98PsF Camera usage conditions Camera settings Genlock input and camera output phase Image and standard signals supplied externally Genlock input [GL PHASE] SDI output (HD) Video output and SDI output (SD) Time code output SDI 1080/23.98PsF [HD SDI] l × l rr When the camera recording format is 720P Camera usage conditions Camera settings Genlock input and camera output phase Image and standard signals supplied externally Genlock input [GL PHASE] SDI output (HD) Video output and SDI output (SD) Time code output SDI VIDEO [HD SDI] l 720P [COMPOSITE] 120H advance 120H delay l × × SDI VIDEO SD (480i/576i) [HD SDI] [COMPOSITE] l 120H advance 120H delay l l l rr When the camera recording format is 480i/576i Camera usage conditions Camera settings Genlock input and camera output phase Image and standard signals supplied externally Genlock input [GL PHASE] SDI output (HD) Video output and SDI output (SD) Time code output SDI VIDEO SD (480i/576i) Disabled None l l Setting and displaying the counter If you display the counter using the button, the counter value is displayed on the time code display of the viewfinder/LCD monitor. Counter value is displayed as "hour:minute:second.frame". The counter value is also displayed during playback. You can set either of two types in the main menu → [DISPLAY SETUP] → [REC COUNTER]. [TOTAL]: The camera will continuously count until reset using the button. Even if you replace the P2 card or turn off the power, the value will be maintained. [CLIP]: Each time you start recording the counter value will clear and the count will start from 0. You can shoot always while checking the recording time of the clip you are currently shooting. @@NOTE tt If the button is pressed while the counter value is displayed, the counter value is reset. It will start again from 0. tt The counter value is displayed by the frame unit. - 106 -