Pentax ZX-60 ZX-60 Manual - Page 23

step 1 xffiltsn:r UNLOADING A FILM 1The film automatically rewinds at the end of the roll. During rewinding, blinks on the LCD panel, indicating that the film is being rewound, the exposure counter counts frame numbers in reverse. 2 When the film is fully rewound, oj blinks on the LCD panel. 3 Open the back cover and remove the film. • I- )ON/OFF OL A :MCATvAvM N. I - 7 7; 4O MEMO • When removing the film from the camera, avoid direct sun light. • A roll of 24-exposure film takes about 20 seconds to rewind. • Before opening the back cover, check that EcE is blinking. • The shutter may be released a frame or more after the specified number of frames have been used as indicated on the film cartridge. However, those extra frames may be lost in processing. When you take important pictures, rewind the film when the film reaches the number of frames indicated on the film cartridge. See page 43. ... EWINDING A FILMINMID-ROLL If you wish to unload the film before exposing all the frames, use this function. 1Set the main switch to the ON position, Depressing the Drive mode button for over 2seconds, Film status information will appear on the LCD. 2 Holding the drive mode button and depress the shutter release button to start rewinding.When the film is fully rewound, rdi blinks on the LCD panel. • The film will be rewound, Film status information on the LCD panel blinks and counts the frame numbers in reverse. • Before opening the back cover, check that al is blinking. OWOFF OA A :CoN.PTvAvM .r___JOWOFF OA A Zdt•VITvAvM