Pentax ZX-60 ZX-60 Manual - Page 27

SELECTING A DRIVE MODE Auto Bracket Exposure Mode When you depressed shutter release button, three consecutive frames will be taken at the different exposure times. The first frame is exposed with no compensation. The second frame is under exposed and the third frame is over exposed. The bracketing amount can be set to ±1/2 EV or ±1 EV. Exposure with no compensation Under exposure Over exposure MEMO • If the exposure compensation amount is small, the effect will not be noticeable with print film. 1Depress the drive mode button until 1: 11", or cayl appears on the LCD panel. MODE 11D DA7E • )0N/OFF 01 A SN.griTvAvM AUTO Tv Av 250 B.0 2 Focus on the subject by depressing the shutter button halfway down. The focus is locked at the first picture and remains locked until three pictures are taken. 3 Take three consecutive pictures, depress and hold down the shutter release button. On MEMO • If you take a finger off from the shutter release button during auto bracketing, the auto bracketing mode will remain effective for about 20 seconds. After that, the auto bracketing exposure for the first bracketed frame will take effect. • Auto bracket does not work in the Bulb timer Mode. • Only the amount of light of the flash can be changed continuously by using the auto bracketing mode following completion of charging of the built-in flash or external flash unit (TTL and P-TTL Auto only). However, in case of an external flash unit, if three consecutive frames are taken while depressing the shutter button, the second and third frame may be taken prior to completion of charging. Always make sure to check completion of charging for each time. How to cancel Auto bracket can be canceled if the power is turned OFF or any other drive mode is set.