Pioneer DV-AX10 Owner's Manual - Page 70

Additional Information When recorded on a VCR or passed through an AV selector, there is disturbance in the playback picture. This is not a malfunction. \ Due to the player's copy protection circuits, connection of this device through a VCR or an AV selector may prevent recording or cause picture problems...Remote control operation is not possible. The CONTROL IN jack on the player is being used. \ Point the remote control at the component that the player is connected to (page 11). The remote control is too far from the player, or the angle with the remote sensor is too wide. \ Be sure to operate the remote from a location within its operating range (page 8). The batteries are exhausted. \ Replace the exhausted batteries with all new batteries (page 8)...Audio is not output or is distorted. The Setup screen Audio 1 menu [Linear PCM Out] setting is set to "Down Sample Off". \ On DVDs that contain copy protection, it may not be possible to play back the audio at 96 kHz. When this type of disc is encountered, even if "Down Sample Off" is selected, the player automatically outputs the digital audio output at a compressed rate of 48 kHz. This is not a malfunction. \ Be sure to make analog audio connections as well as digital connections (pages 14 and 18). The disc is dirty. \ Refer to "Disc Care" (page 66). The connection plugs are not inserted fully into the terminals or are not connected. \ Check that all connection plugs are firmly inserted. The connection plug or terminal is dirty. \ Check that the plugs and terminals are wiped clean of dirt, etc. Audio cable connection is wrong. \ Check to make sure that the audio cables are connected correctly (pages 14 and 18). Connection is made to the stereo amplifier's PHONO input terminal. \ Change connection to any input terminal except PHONO. The pause mode is engaged. \ Press PLAY 3 or PAUSE 8 to exit the pause mode. Stereo amplifier operation is incorrect. \ Check input (CD, AUX, etc.) selector to determine if it is selected for DVD playback. Noticeable difference in DVD, SACD and CD volume. DVDs, CDs and SACDs seem to play at different volumes. \ This is a result of the different recording methods used. \ The volume of SACD is about half that of CD...Audio mix does not sound right or sounds incomplete (for example, the dialog of the actors cannot be heard). Audio output selection is incorrect. \ When "5.1 Channel" is selected, Dialog is not output from the front left and right speakers. When "2 Channel" is selected, sound is only output through the front left and right speakers (page 21)...Caution Static electricity or other external influence may cause malfunctioning of this unit. In this case, unplugging the power cord and then re-plugging it in will usually reset the unit for proper operation. If this does not correct the problem, please consult your nearest PIONEER service center. 70 En