Plantronics DISCOVERY 610 User Guide - Page 69

Using voice activated dialLing NOTE: To use voice activated dialling, the voice activated dialling feature must be enabled on your device. See your Bluetooth device manual for instructions. With the headset on, one long press on the call control button activates the voice activated dialling feature on the headset. MULTIPLE USES OF A LONG PRESS ON THE CALL CONTROL BUTTON Headset Function State of the Bluetooth Device result Turn on power Power off Turns the power on Re-link to Bluetooth device Reject call Power on Link dropped Power on Linked Incoming call Re-links the device Disconnects the call or sends the call to voice mail depending on your device Transfer a call between Headset and Bluetooth device Voice activated dialing Power on Linked On a call Power on Linked No call Transfers the call from one device to another Activates the voice recognition feature Status Indicators Headset Status Powering on Power on Powering off Power off Charging battery Battery fully charged Discovery state Missed call Ringing On Line Indicator (OLI) Low battery Headset status indicator Blue light appears and flashes every 6 seconds Blue light flashes every 6 seconds Red light appears and goes off Indicator is not lit Red light is on Red light is off Indicator flashes blue and red for 30 seconds Infrequent flashing blue/red Press any button to cancel Rapid flashing blue/red Blue flash every 10 seconds Flashes red  Troubleshooting My Headset does not work with my phone. POSSIBLE CAUSE SOLUTION Headset was not in discovery mode when mobile phone menu selections were made. See page 5 "Bluetooth Pairing". Incorrect menu selections were made on your cellular phone. See page 5 "Bluetooth Pairing". I DID NOT ENTER MY PASS KEY. POSSIBLE CAUSE SOLUTION Your phone did not locate the headset. Repeat the Pairing process on page 5. Incorrect menu selections were made on your cellular phone. Repeat the Pairing process on page 5. Callers cannot hear me. POSSIBLE CAUSE SOLUTION Mute is turned on. Press both sides of the volume/mute button simultaneously. I cannot hear caller/dialLing tone. POSSIBLE CAUSE SOLUTION The headset is not turned on. Press the call control button for 2 seconds until you hear a beep or see the headset status indicator glow blue. Your headset is out of range. Move the headset closer to the phone or Bluetooth device. Your headset battery is flat. Charge your battery using the AC power adapter supplied. The listening volume is too low. Press the top part of the volume/mute button to increase the sound heard in the headset.