Samsung SRD-470D User Manual - Page 54
Setting the Motion Detection Area
View all Samsung SRD-470D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
using the DVR Motion Detection You can set target detection region and motion, as well as the alarm signal output. When the motion detection region is set, it detects motion within the area. Using the mouse may help make setup easier. 1. Use the up/down buttons () in window to move to , and press [ENTER] button. A window of motion detection area setup appears. 2. Use direction buttons to move to a desired item, and set the value. Motion Detection CH Mode Sensitivity Alarm 1 OFF Level10(High) None 2 OFF Level10(High) None 3 OFF Level10(High) None 4 OFF Level10(High) None • Mode : Sets whether to activate motion detection. • Sensitivity : Sets the sensitivity level of the motion detection. • Alarm : Sets the alarm output method. For further information on alarm output, refer to "HDD Alarm > Alarm". (Page 45) OK Cancel • Alarm Duration : Sets the duration of alarm signal and alarm sound. 3. When the motion detection setup is done, press . Alarm Duration 10 sec 10 sec 10 sec 10 sec Motion Region Setting the Motion Detection Area Select . When "Motion Region" window appears, select a channel for detection and set the area of motion detection. • To set the area in "Motion Region" window In the "Motion Region" window, select desired region from < >. Motion Region 1 CH • To set the area using selection In the "Motion Region" window, you can select cells Individual OK Cancel Apply to All CH individually by using . When selected , "Motion Region" window disappears and you can select cells one by one. When the motion area setup is done, Right-click to select in the context menu or the [MENU] button on the remote control or front panel to display the "Motion Region" window again. - Select : Selected cell is set to be a part of motion detection area. - Unselect : Selected cell is removed from the motion detection area. - Inverse : Unselected cells are set to be the motion detection area. - Menu : After selecting individual motion areas, move to the "Motion Region" window. If selected , selected motion area is applied to all channels. Select Unselect Inverse Menu When the motion detection setup is done, press . 54_ using the DVR