Sharp ZQ160 Operation Manual - Page 31
Precautions, Operating, Batteries, Replacement
View all Sharp ZQ160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Battery Replacement Batteries used Type Lithium battery Lithium battery Model CR2032 CR2032 Quantity 2 1 Use Unit operation Memory backup • Do not remove both the operating and memory backup batteries at the same time. Doing so will clear the memory of its contents. • Be sure to write down any important information stored in the memory before replacing the batteries. 1. Precautions Since improper use of the batteries may cause leakage or explosion, strictly observe the following instructions. • Insert the battery with its positive side (+) correctly positioned. • Never throw batteries into a fire because they might explode. • Keep batteries out of the reach of children. • When batteries become low, remove them from the Organizer immediately to avoid battery leakage and corrosion inside the Organizer. • Do not expose the battery to the fire as it might explode. Because the batteries in the Organizer were installed at the factory, they may become depleted before the specified expiration time is reached. 2. Operating Batteries Replacement (1) Battery replacement time When " BAIT " is displayed, immediately replace the batteries with new ones. If the battery level is very low, the alarms or the key touch tone may not sound, or similarly the Backlight may remain on for less than the set interval or it may not function. Continued use of the Organizer with low batteries can alter or clear the memory contents. Memory contents may be lost if the batteries are improperly replaced or if the following instructions are disregarded. (2) Replacing the batteries • Make sure the power is turned off before replacing the batteries. • Do not press loNI until the battery replacement procedure is completed. 1. Press OFF to turn the power off. 2. Loosen the screw (counterclockwise) and remove the battery holder cover on the back of the unit. Q 3. Remove the used batteries using a ball-point pen or similar object. xx • Do not use a mechanical pencil or sharp pointed object. 4. Install 2 new, batteries with the positive sides (+) facing up. 5. Replace the holder cover and secure it with the screw. 6. Press loN I to turn the power on. If nothing appears on the display, press the RESET switch and press and hold loN1 for 2 or 3 seconds. 7. Set the clock to the correct time. 29