TEAC w-865r Owners Manual - Page 16
Recording either TAPE I or TAPE II
View all TEAC w-865r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Recording (either TAPE I or TAPE II) 4 5 8A 5 8A 5 Press the RECORD button. 31 27 6 72 1 Turn on the power. The deck enters the record-pause mode. "J" and " REC " will light on the display. 6 Adjust the recording level. 2 Load a tape for recording. Side "A" facing you Press the EJECT button (L) to open the cassette compartment. Insert the cassette tape with its open edge facing down, side "A" facing you. Then close the cassette compartment by pushing in the cassette door until it clicks shut. < If the erasure prevention tabs of the loaded cassette tape have been broken off, stick a piece of adhesive tape over the hole(s). < With this cassette deck you can use Normal (Type I) and Chrome (Type II) tapes for recording. 3 Set the REV MODE switch. Start playback of your recording source and set the REC LEVEL control knob so that the level meter indicates "0 dB" at peaks. 7 Set the recording direction. Recording is made in the direction indicated by the play/record direction indicator (h or y). To change this direction, press the opposite direction play button (h or y). Be careful not to press play button whose arrow points in the same direction as the indicator. Doing so will start recording. u: Set to this position to record on one side only. j or p: Set to either of these positions to record on both sides. 8 When everything is ready, start recording by pressing the PAUSE button or the play button whose arrow points in the same direction as the indicator. 4 Set the DOLBY NR switch. < To record on both tape sides, set the REV MODE switch to "j" or "p" and press the forward play button (y). If you press the reverse play button (h), recording will be done only on side "B". < To stop recording, press the stop button (H). Set the switch to ON to record with Dolby Noise Reduction. Set to OFF to record without Dolby Noise Reduction. 16