TEAC w-865r Owners Manual - Page 22
Synchro Reverse Dubbing from TAPE I to TAPE II
View all TEAC w-865r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Synchro Reverse Dubbing (from TAPE I to TAPE II) 43 5 3 2 1 When you use this dubbing function and a shorter tape reaches the end of side "A", it momentarily stops until the other tape reaches the end of side "A". Then both tapes automatically switch over to side "B" and recording and playback re-start simultaneously. 1 1 Insert a cassette tape for playback into the TAPE I compartment and a cassette tape for recording into the TAPE II compartment. If TAPE I is shorter than TAPE II: 1. When TAPE I reaches the end of side "A", TAPE I stops and TAPE II enters the "blank recording" mode. 2. When TAPE II reaches the end, both TAPE I and ll are reversed simultaneously. TAPE l starts reverse play and TAPE II resumes recording. 3. When TAPE I reaches the end of side "B", both TAPE I and ll stop simultaneously. 2 Set the REV MODE switch to the two-way (j) position. If TAPE I is longer than TAPE II: 1. When TAPE II reaches the end of side "A", TAPE Il enters the record-pause mode, while TAPE I continues playback. 2. When TAPE I reaches the end, TAPE I starts reverse play and TAPE II starts recording . 3. When TAPE Il reaches the end of side "B", both TAPE I and ll stop simultaneously. 3 Check the recording direction of both decks. If the reverse direction indicator (h) lights on the display, press the PAUSE button followed by the forward play button (y). Then, be sure to press the stop button (H) to get out of the pause mode. < Be careful not to press play button whose arrow points in the same direction as the indicator. Doing so will start playback. < You don't need to adjust the recording level or set the Dolby NR system, as both depend on the pre-recorded source tape. 22