TEAC w-865r Owners Manual - Page 9
Counter clear buttons CLEAR I and CLEAR II - remote
View all TEAC w-865r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
ENGLISH In this manual we only refer to the buttons on the cassette deck itself. However, their remote counterparts can be used in the same way. A Power switch This switch toggles the unit on/off. The equipment draws nominal non-operating power from the AC outlet with its POWER switch in the OFF position. B Reverse mode switch (REV MODE) This switch is used to switch between reverse modes. C TIMER switch This switch is provided for use with a commercially available audio timer, to allow timer controlled recording or playback. Normally, leave this switch to the OFF position. D DOLBY NR switch This switch toggles the Dolby Noise Reduction system on/off. In playback you need to set this switch to the same position as when the recording was made. E TAPE I compartment F Remote sensor This receives remote commands. When using the remote control unit, point it at this sensor. G Counter clear buttons (CLEAR I and CLEAR II) Pressing these buttons reset the tape counter readings for TAPE I and TAPE II, respectively. H INTRO CHECK button Pressing this button allows you to identify recorded segments by listening to the first 15 seconds of each segment. I Synchro reverse button (SYNC REV) Pressing this button activates the synchro reverse dubbing function. J BLANK SCAN button This button toggles Blank Scan on/off. K Display This shows tape counters, level meters, etc. N TAPE II compartment O EJECT buttons Pressing these buttons opens the TAPE I and TAPE II compartments. P Tape transport control buttons RECORD Pressing this button shifts the corresponding deck to recordpause mode. When you use the remote control unit, you need to press a pair of buttons at the same time to shift either deck to recordpause mode. PAUSE Pressing this button temporarily stops playback or recording. Recording mute (REC MUTE) This button is for creating the 4-second blank space needed for proper operation of the Computomatic Program Search (CPS) function. m/, Fast-forward/Rewind H Stop of playback/record h/y Reverse side play/Forward side play Q Headphones jack (PHONES) Plug your headphones into this jack. R PITCH CONTROL This control is used to vary the playback speed. S REC LEVEL control This control is used to adjust the recording level. T MIC jack and level control Insert your microphone into this jack and use the knob to adjust the level of mic input. < The MIC jack is mono. You cannot use a stereo microphone with this cassette deck. L Parallel record button (PARALLEL REC) This button lets you simultaneously record on both decks. M Dubbing start button (DUB START) This button is used when copying the contents of a tape from TAPE I to TAPE II, either at normal or high speed. On the remote control unit a pair of buttons is provided for each speed. You need to press both buttons at the same time. 9