TP-Link T1500-28TC TL-SL2428 T1500-28TCUN V1 Configuration Guide - Page 605

Configuring Maintenance System Log Configurations 3.1 Using the GUI 3.1.1 Configuring the Local Log Choose the menu Maintenance > Log> Local Log to load the following page. Figure 3-1 Configuring the Local Log Follow these steps to configure the local log: 1) Select your desired channel and configure the corresponding severity and status. Channel Severity Status Sync-Periodic 2) Click Apply. Local log includes 2 channels: log buffer and log file. Log buffer indicates the RAM for saving system log. The channel is enabled by default. The information in the log buffer is displayed on the Maintenance > Log> Log Table page. It will be lost when the switch is restarted. Log File indicates the flash sector for saving system log. The information in the log file will not be lost after the switch is restarted and can be exported on the Maintenance > Log > Backup Log page. Specify the severity level of the log information that is saved to the selected channel. Only the log with the same or smaller severity level value can be saved. There are 8 severity levels marked from 0 to 7. The smaller value means the higher priority. Enable or disable the channel. By default, the log information is saved in the log buffer immediately, and synchronized to the log file every 24 hours. If necessary, you can modify the log synchronization frequency using the CLI. 3.1.2 Configuring the Remote Log Remote Log enables the switch to send system logs to a host. To display the logs, the host should run a log server that complies with the syslog standard. Configuration Guide 584